WEDGE Command:

AutoCAD Command List

The WEDGE command allows you to create a three-dimensional wedge shaped solid.

To access the WEDGE command you can:

type wedge at a Command: prompt

OR

click on the Wedge button (if the Solids toolbar is displayed).

--Prompt: Current wire fram density: ISOLINES=4
--Prompt: Specify first corner of wedge or [CEnter] <0,0,0>: Use a coordinate or an Osnap to locate the first corner of the wedge on the XY plane.
--Prompt: Specify corner or [Cube /Length]: Indicate the position of the opposite diagonal corner for the wedge's base on the XY plane.


OPTIONS:

-The CEnter option allows you to specify the center of box that would contain the wedge. The center is at the middle of the slope of the wedge.

-The Cube option requires only one coordinate value to create a wedge that is half of a cube.

-The Length option will prompt you for the X, Y, Z coordinates separately.

--Prompt: Specify height: Type a height value (positive or negative).

The Wedge should appear.

Return to the AutoCAD Command List.